メインコンテンツにスキップ

はじめに

The hard drive provides permanent data storage. Hard drive failure causes crushing laptops and missing files. If your hard drive is diagnosed of irreversible problems, replace it the sooner the better using this guide to prevent larger losses.

パーツ

パーツは指定されていません。

  1. Turn off the laptop and disconnect all device cords.
    • Turn off the laptop and disconnect all device cords.

  2. Flip the laptop over so the bottom is facing you.
    • Flip the laptop over so the bottom is facing you.

  3. Insert the tip of the Plastic #3 Spudger into the battery release switch. Insert the tip of the Plastic #3 Spudger into the battery release switch.
    • Insert the tip of the Plastic #3 Spudger into the battery release switch.

  4. Press down and slide to the right and hold in that position.
    • Press down and slide to the right and hold in that position.

  5. Take your other hand to slide the battery away from the laptop to remove. Take your other hand to slide the battery away from the laptop to remove. Take your other hand to slide the battery away from the laptop to remove.
    • Take your other hand to slide the battery away from the laptop to remove.

  6. Remove nineteen screws from the back panel using a Phillips #0 Screwdriver . Remove nineteen screws from the back panel using a Phillips #0 Screwdriver .
    • Remove nineteen screws from the back panel using a Phillips #0 Screwdriver .

  7. Run the plastic opening tool across from one corner to another along the edge. Separate the keyboard panel gently. Lift the keyboard slowly from the laptop but do not lift completely because there are ribbon cables attached.
    • Run the plastic opening tool across from one corner to another along the edge.

    • Separate the keyboard panel gently.

    • Lift the keyboard slowly from the laptop but do not lift completely because there are ribbon cables attached.

  8. Disconnect the two keyboard assembly ribbon cables from motherboard. To release small ribbon cable, use spudger or fingers to flip gray bar along edge over.
    • Disconnect the two keyboard assembly ribbon cables from motherboard.

    • To release small ribbon cable, use spudger or fingers to flip gray bar along edge over.

    • To release larger ribbon cable, use pry tool or spudger to slide white plastic clip forward.

  9. Pull up the release tab beside the hard drive.
    • Pull up the release tab beside the hard drive.

    • Disconnect portion of ribbon cable that is covering the hard drive.

    • Handle the ribbon carefully. Do not break the metal contact.

    • While reconnecting the ribbon after replacing a new hard drive, face the blue side with a label up. Make sure the black line beside the sticker is not crooked, so that the ribbon is tight.

  10. Remove the hard drive screw using Phillips #0 Screwdriver.
    • Remove the hard drive screw using Phillips #0 Screwdriver.

  11. Pull the hard drive out gently. Be aware that it is connected to the adapter.
    • Pull the hard drive out gently. Be aware that it is connected to the adapter.

    • Gently remove adapter by pulling on both ends simultaneously to separate it from the hard drive.

まとめ

To reassemble your device, follow these instructions in reverse order.

Siyu Jia

メンバー登録日: 2018年10月22日

133 ポイント

1ガイドが承認済み

チーム

UC Davis, Team S4-G5, Lore Fall 2018 UC Davis, Team S4-G5, Lore Fall 2018人のメンバー

UCD-LORE-F18S4G5

3 メンバー

5のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 3

過去 30 日: 10

今までの合計 154