メインコンテンツにスキップ

修理を始めるには

修理する権利

ストア

はじめに

Removal of the CMOS battery is a very quick and simple procedure. The CMOS battery will lose its charge over time and cannot be recharged, therefore you will need to replace it from time to time (very infrequently). No special caution is needed to follow this guide other than to be gentle with the laptop and do not to touch any electrical components not mentioned in the guide.

パーツ

パーツは指定されていません。

  1. Move the battery catch to the "unlocked" position. Pull back the second spring-loaded battery catch until the battery pops up. Remove the battery.
    • Move the battery catch to the "unlocked" position.

    • Pull back the second spring-loaded battery catch until the battery pops up.

    • Remove the battery.

  2. Turn the notebook around to face you. There are two Phillips #00 screws securing the cover panel to the rest of the notebook. Remove these screws. There are two Phillips #00 screws securing the cover panel to the rest of the notebook. Remove these screws.
    • Turn the notebook around to face you.

    • There are two Phillips #00 screws securing the cover panel to the rest of the notebook. Remove these screws.

  3. Use a spudger to release the panel from the plastic retaining clips keeping it in place. Do not apply too much force, or you may break the clips. Remove the panel and set it aside.
    • Use a spudger to release the panel from the plastic retaining clips keeping it in place.

    • Do not apply too much force, or you may break the clips.

    • Remove the panel and set it aside.

  4. After removing the cover panel, you will see the hard drive, the RAM, and the CMOS battery. The CMOS battery is the silver coin-like object in the center.
    • After removing the cover panel, you will see the hard drive, the RAM, and the CMOS battery.

    • The CMOS battery is the silver coin-like object in the center.

  5. Press the tip of the spudger underneath the CMOS battery with very slight force. Press down on the opposite side of the battery while prying the battery upward with the spudger. After the battery is mostly lifted from the slot, you may pull out the battery with your fingers.
    • Press the tip of the spudger underneath the CMOS battery with very slight force.

    • Press down on the opposite side of the battery while prying the battery upward with the spudger.

    • After the battery is mostly lifted from the slot, you may pull out the battery with your fingers.

終わりに

To reassemble your device, follow these instructions in reverse order.

5 の人々がこのガイドを完成させました。

Bill Murray

メンバー登録日: 2016年10月24日

531 ポイント

2のガイドは作成済み

チーム

UMass Dartmouth, Team 2-6, Isaacson Fall 2016 UMass Dartmouth, Team 2-6, Isaacson Fall 2016人のメンバー

UMASSD-ISAACSON-F16S2G6

3 メンバー

5のガイドは作成済み

0 件のコメント

コメントを追加

統計データを表示:

過去 24時間: 2

過去 7 日: 18

過去 30 日: 89

今までの合計 9,114