2018-2020 Honda Accord Taillight Bulb Replacement (2018, 2019, 2020)

はじめに

This guide provides step by step instructions on how to replace a 2018-2020 Honda Accord taillight and bulb.

Taillights are an essential part of a vehicle as they help alert other drivers to your presence on the road. If not repaired, they can result in traffic tickets and also cause accidents. This guide offers instructions to replace the taillight and bulbs to prevent these issues.

必要な工具と部品

手順1 Tail Light

2018-2020 Honda Accord Taillight Bulb Replacement, Tail Light: 手順 1、 2の画像 1

2018-2020 Honda Accord Taillight Bulb Replacement, Tail Light: 手順 1、 2の画像 2

Press the trunk lever button on the driver's side door to open the trunk.
Alternately, press and hold the trunk release button on the key fob for 3-5 seconds to open the trunk.

翻訳

手順2

There is a little grey/black plastic trim cover behind the taillight that will need to come off.
Using a plastic pry bar, pry out on the edge (top and bottom) of the plastic trim cover to remove it.
You could also stick your flat head screwdriver behind the plastic cover and gently pull it from the top and then from the bottom.

翻訳

手順3

2018-2020 Honda Accord Taillight Bulb Replacement: 手順 3、 3の画像 3

Remove the two 8 mm screws behind the tail light assembly using a Phillips #2 screwdriver.

翻訳

手順4

Remove the taillight assembly by sliding or pushing the taillight towards the outside of the car.
Apply gentle force to remove the taillight to prevent it from breaking.

翻訳

手順5

Unplug the wire harness (coloured black) that connects to the taillight by squeezing on the sides and pulling out.

翻訳

手順6

Rotate the light bulb socket (yellow) counterclockwise and carefully pull it out to remove the bulb.
Replace the light bulb

翻訳

手順7

Insert the wiring harness back into its socket.

翻訳

手順8

Insert the bulb housing back into the taillight housing.
Lock the bulb housing in place by turning the bulb clockwise (about 1/4 to 1/2 turn).

翻訳

手順9

Re-insert the taillight by sliding the light gently into the slot.
Press firmly to ensure the taillight is in place and the screw holes line up.

翻訳

手順10

Use the Phillips #2 screwdriver to re-attach the two 8 mm screws back into the back of the taillight.

翻訳

手順11

2018-2020 Honda Accord Taillight Bulb Replacement: 手順 11、 3の画像 3

Reinstall the plastic trunk trim panel by lining the two clips up, and pressing down to snap them back into place.
Re-attach the rubber lining behind the plastic trim by pressing the rubber firmly to fit.

翻訳