2013-2018 Jeep Wrangler Sun Visor Replacement (2013, 2014, 2015, 2016, 2017, 2018)

はじめに

This guide demonstrates the process of replacing a sun visor on a 2016 Jeep Wrangler.

Sun visors provide cover from the sun, which is an important safety feature when driving. If there is a glare or bright light when driving, visibility may be reduced. If the sun visor becomes worn and ineffective, this guide will help. If you need to replace the sun visor of your 2013-2018 Jeep Wrangler, follow this guide.

必要な工具と部品

手順1 Sun Visor

2013-2018 Jeep Wrangler Sun Visor Replacement, Sun Visor: 手順 1、 1の画像 1

Lower the old sun visor to the lowest position.

編集

手順2

Locate the screw that secures the sun visor to the mounting bracket.
This screw is sometimes covered by a small plastic bracket.
Remove the plastic cover using a flathead screwdriver or trim-removing tool

編集

手順3

Use a Torx T20 or T25 to remove the 12 mm screw that attaches the sun visor to the bracket.

編集

手順4

Slide the old sun visor off the mounting bracket.
Keep the old sun visor and any hardware in case it's needed for the replacement.

編集

手順5

Slide the new sun visor onto the mounting bracket, aligning the holes for the screws.

編集

手順6

2013-2018 Jeep Wrangler Sun Visor Replacement: 手順 6、 3の画像 3

Insert the screw into the mounting bracket and tighten it with the Torx T25 screwdriver.
Make sure it's snug but not too tight.
Tightening the screw too tight might damage the plastic.
If your sun visor had a plastic cover concealing the screw, put it back in place.
Test the new sun visor by moving it into different positions to make sure it functions correctly.