2006-2011 Honda Civic Cruise Control Switch Replacement (2006, 2007, 2008, 2009, 2010, 2011)

はじめに

For a system that most people use regularly when it comes to driving, the cruise control system can definitely start to malfunction over time, especially in older models of cars. Thankfully for the Honda the biggest issue that ends up happening with this system is simply that the button looses the hold that it use to have when it was new. With this guide, you will be able to replace the switch on your own and fix all your cruising woes. This particular guide is demonstrated on a 2009 Honda Civic.

必要な工具と部品

手順1 Cruise Control Switch

2006-2011 Honda Civic Cruise Control Switch Replacement, Cruise Control Switch: 手順 1、 1の画像 1

Disconnect your car battery with the 10 mm wrench so as not to shock yourself when working on the car.
You don't need to disconnect it completely, just removing one of the connecting cables is adequate.

翻訳

手順2

2006-2011 Honda Civic Cruise Control Switch Replacement: 手順 2、 3の画像 3

Take off the plastic cover underneath the wheel with a prying tool to access the airbag connector.
Disconnect the airbag connector.

翻訳

手順3

2006-2011 Honda Civic Cruise Control Switch Replacement: 手順 3、 3の画像 3

Use a T30 Torx bit attached to a torque wrench and take out the screws on each side of the steering wheel that connects the horn cover.

翻訳

手順4

2006-2011 Honda Civic Cruise Control Switch Replacement: 手順 4、 3の画像 3

Remove the horn cover and disconnect the horn.
After removing the horn cover, make sure to disconnect the cruise control switch itself. To do this, simply press the tab on the blue plug as shown by the red arrow and pull it out.

翻訳

手順5

2006-2011 Honda Civic Cruise Control Switch Replacement: 手順 5、 3の画像 3

Using your Phillips screwdriver, remove the six screws on the back of the steering wheel and the four main screws connecting the trim to the main steering wheel.
To get to some of these screws you might need to move the steering wheel itself, so make sure your key is in the ignition in order to do so.
Also to note, two of the screws are slightly hidden and are near the same area of the screws for the airbag.

翻訳

手順6

Gently remove the trim from the steering wheel so that you can access the two screws on the back connecting the switch to the wheel.
Don't forget to also disconnect the switch itself either at this step or the one prior so that you may actually remove said switch.

翻訳

手順7

Use a Phillips screwdriver to remove the two screws on the back of the switch so you can replace it with your new one.
For models with audio controls in the steering wheel, the number of screws goes from two to four as there is the other side to disconnect.

翻訳