1999-2001 Mazda Miata (MX-5) Door Speaker Replacement (1999, 2000, 2001)

はじめに

As Miatas get older, some parts start to wear out. This includes the car's audio system. If your audio makes a rattling or vibrating sound, it may be time to replace the speakers.

This guide will show how to remove the door speaker on a 1999-2001 Mazda Miata, so that it can be replaced or upgraded.

Step 1 is optional but is generally good practice when working with the electrical system.

Before starting, it is recommended that you get replacement retainer clips. They break easily. Be sure to power down the ignition, place the car in park, and engage the parking brake.

必要な工具と部品

手順1 Door Speaker

1999-2001 Mazda Miata (MX-5) Door Speaker Replacement, Door Speaker: 手順 1、 2の画像 1

1999-2001 Mazda Miata (MX-5) Door Speaker Replacement, Door Speaker: 手順 1、 2の画像 2

The battery is in the right side of the rear cargo compartment. It can be found by moving the carpet and wood cover.
With a 10mm wrench, remove the positive battery terminal.
Do not let any metal in contact with the positive battery terminal contact any other metal item. This might make sparks.

編集

手順2

1999-2001 Mazda Miata (MX-5) Door Speaker Replacement: 手順 2、 3の画像 3

Remove the three trim panel retainer clips.
Old clips might break easily. Be extra careful when removing them or get spares.

編集

手順3

1999-2001 Mazda Miata (MX-5) Door Speaker Replacement: 手順 3、 3の画像 3

Remove the three screws that hold the door panel in place.
These screws are all different, so keep note of where they all go. The short screw goes in the door latch; the long screws go in the door handle.

編集

手順4

Remove the cover around the door latch by pulling the handle and rotating the cover.

編集

手順5

Remove the door panel by pulling the bottom out and lifting up.

編集

手順6

1999-2001 Mazda Miata (MX-5) Door Speaker Replacement: 手順 6、 3の画像 3

Remove the four screws holding the plastic speaker mount.
As you remove the screws, don't let the speaker fall out and pull the wire.

編集

手順7

1999-2001 Mazda Miata (MX-5) Door Speaker Replacement: 手順 7、 3の画像 3

Detach the connector that powers the speaker by pressing down on the top latch and gently pulling.
A small screwdriver might help with the latch but be careful. Old plastic can be brittle.

編集