はじめに

Replacing burnt out or broken bulbs is a quick and easy fix that makes your car easier to see from behind, helping to prevent accidents.

Locate the plastic casing that holds the trunk liner in place, directly behind the tail light.
  • Locate the plastic casing that holds the trunk liner in place, directly behind the tail light.

  • Unscrew the plastic casings.

コメントを追加する

Make sure to put some pressure on the tail light itself so it does not fall out when you unscrew it.
  • Make sure to put some pressure on the tail light itself so it does not fall out when you unscrew it.

  • Unscrew the three plastic wing nuts located behind the tail lights.

コメントを追加する

When the tail light assembly comes loose, do not fully remove it because it may damage the connected wires.
  • When the tail light assembly comes loose, do not fully remove it because it may damage the connected wires.

  • Carefully pull the tail light away from the car to expose the connected wires.

コメントを追加する

Unclip the rear panel of the tail light assembly.  There are two clips on the top and two on the bottom. Remove the rear panel from the rest of the assembly. Remove the rear panel from the rest of the assembly.
  • Unclip the rear panel of the tail light assembly. There are two clips on the top and two on the bottom.

  • Remove the rear panel from the rest of the assembly.

コメントを追加する

Do not pull on the bulb, handle it gently because it is fragile.
  • Do not pull on the bulb, handle it gently because it is fragile.

  • Grab the plastic base of the bulb and gently wiggle it free.

コメントを追加する

When handling the new bulbs, avoid touching the glass as much as possible because this can reduce the life of the bulb.
  • When handling the new bulbs, avoid touching the glass as much as possible because this can reduce the life of the bulb.

  • Gently push the new bulb into the plastic housing.

コメントを追加する

After putting the new bulbs in, turn the desired lights on to check that the newly installed bulbs work correctly.
  • After putting the new bulbs in, turn the desired lights on to check that the newly installed bulbs work correctly.

  • These bulbs have different functions including blinkers, brake lights, hazard lights, and back-up lights. They will only turn on when the necessary signal is sent.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

4 の人々がこのガイドを完成させました。

Sank Yang

メンバー登録日: 2012年10月03日

345 ポイント

5のガイドは作成済み

チーム

Cal Poly, Team 9-15, Amido Fall 2012 Cal Poly, Team 9-15, Amido Fall 2012人のメンバー

CPSU-AMIDO-F12S9G15

4 メンバー

5のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 5

過去 7 日: 59

過去 30 日: 266

今までの合計 12,908