1992-1999 BMW 3 Series Driver Side Airbag Replacement (1992, 1993, 1994, 1995, 1996, 1997, 1998, 1999) - iFixit 修理ガイド

はじめに

Use this guide to replace the driver side airbag in your BMW E36. This procedure was done on a US 1997 M3 with the four spoke steering wheel.

必要な工具と部品

手順1 Driver Side Airbag

This step is not necessary, but it made it easier for me to get at the steering column trim mounting screw. Feel free to skip this if you'd like.
Remove the two screws securing the upper edge of the knee bolster.
Pull the upper edge down to give access to the underside of the steering wheel.

手順2

Remove the lower steering column trim mounting screw.
Remove the lower steering column trim.

手順3

Make sure that the battery has been disconnected for at least 30 minutes before continuing further to ensure that the airbag light does not come on.
Disconnect the orange SRS connector.

手順4

Completely loosen the two T30 Torx screws behind the steering wheel while supporting the airbag unit from the front.
Make sure to support the airbag to prevent it from falling out.

手順5

Lift the airbag unit up and away from the steering wheel.
Disconnect the orange harness connector from the rear of the airbag unit.
The airbag should now be free to be removed.

終わりに

To reassemble your device, follow these instructions in reverse order.

作成者

1人の作成者と共同作成されました。

Geoff Wacker

メンバー登録日: 09/30/13

90,038 ポイント

89のガイドは作成済み

+41 個以上のバッジ

0 件のコメント

統計データ:

過去 24時間: 0

過去 7 日: 13

過去 30 日: 23

今までの合計 568