1. Firstly Disconnect  battery Always take the negative terminal off first.
    • Firstly Disconnect battery

    • Always take the negative terminal off first.

    • '''General Tip After disconnecting the battery leave the car for about 10 mins , This lets any residual energy left in the electrical system to dissapate. It is good practise whatever the job

  2. Unlatch the 2 clasps. Loosen screw on metal band.
    • Unlatch the 2 clasps.

    • Loosen screw on metal band.

  3. Disconnect electronic sensor. Press on the 2 latches, pulling the cable away from sensor.
    • Disconnect electronic sensor.

    • Press on the 2 latches, pulling the cable away from sensor.

  4. Pro Tech ツールキットを含むご注文、もしくは総額 $100ドル以上のご注文については送料無料です。

    当社のショップを閲覧する
  5. Disconnect hose from MAFS. Remove MAFS.
    • Disconnect hose from MAFS.

    • Remove MAFS.

  6. Steps 4-6 are for cleaning only.
    • Steps 4-6 are for cleaning only.

    • Spray MAFS cleaner along direction of travel, shown by arrow.

  7. Clean electronic coupling with electronics cleaner. Clean electronic coupling with electronics cleaner.
    • Clean electronic coupling with electronics cleaner.

  8. Inject conducting lubricant into  MAFS electronic coupling. Inject conducting lubricant into  MAFS electronic coupling.
    • Inject conducting lubricant into MAFS electronic coupling.

  9. Re attach MAFS to air filter housing and intake hose. Tighten screw on metal band. Latch clasps on either side of MAFS.
    • Re attach MAFS to air filter housing and intake hose.

    • Tighten screw on metal band.

    • Latch clasps on either side of MAFS.

  10. Re attach electronic cable to MAFS.
    • Re attach electronic cable to MAFS.

まとめ

To reassemble your device, follow these instructions in reverse order.

Isaac Nitschke

メンバー登録日: 2010年10月11日

61 ポイント

5のガイドは作成済み

チーム

Cal Poly, Team 3-28, Regan Fall 2010 Cal Poly, Team 3-28, Regan Fall 2010人のメンバー

CPSU-REGAN-F10S3G28

4 メンバー

9のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 3

過去 30 日: 20

今までの合計 8,097