修理を始めるには コミュニティ ストア

モデル番号はA1366/8もしくは16GB容量

175回答 すべてを表示

オプション

iPod Nano 6th survives wash, but screen doesn't work after replacement

After being rescued from the washing machine 10 days ago and living in a sealed box with silica gel then submerged in rice, I thought my nano was toast but surprisingly, all was not lost.

The touch screen worked, it was able to sync (and was restored) and could play music just fine. The only problem - the screen under the digitizer doesn't work.

So I purchased on from eBay, which arrived today - followed the guide on iFixit, but unfortunately it did not work either.

There doesn't appear to be any signs of water damaged from the washer (not build up of any suds!) but I'm a little lost.

Anyone have any ideas or tricks that I could try?

Cheers!

Tom

この質問に回答する 同じ問題があります

この質問は役に立ちましたか？

はい いいえ
スコア -1
コメントを追加

1 件の回答

フィルタ：
参考になった順 新しい順 古い順

オプション

Tom, if you have a new display and it is all dark, double check your connector for any bend and especially. corroded pins. Clean the logic board thoroughly with isopropyl alcohol as well as all the connectors. Just a bit of corrosion can lead to failure. An ultrasonic cleaning would be great, of you have access to it. Jewelers have those machines to clean some of their merchandise. The only other thing that could be at fault is a shortened inductor/coil or a short in the backlight circuitry. Since it is an iDevice, it will be extremely difficult to find any diagrams for this.

このアンサーは役に立ちましたか？

はい いいえ
スコア 0

2 件のコメント:

I wonder where the backlight circuit/IC is?

さんによる

Do you have your iPod disassembled? Post some clear high resolution images with your question that you posted as an answer, lets see if we can figure it out:-)

さんによる

コメントを追加

回答を追加する

Tom Mortimer さん、ありがとうございました！
統計データ:

過去 24時間: 0

過去 7 日: 1

過去 30 日: 2

今までの合計 3,443