修理を始めるには コミュニティ ストア

13インチアルミ製Unibody, 2.0 or 2.4 GHz Core 2 デュオプロセッサモデルです。

574回答 すべてを表示

オプション

How to reattach fan and subwoofer connectors to the logic board?

Hi,

I followed the "lower case" disassembly instructions for my MacBook. Everything went fine.

Now when I tried to reassemble everything, there's a problem with to of the connectors: the subwoofer connector and especially the fan connector. I pried them off the logic board as described, but now I cannot see how they can be reattached. There is no socket, just pins on the board. Do I need to use glue to attach those connectors? And if so, what kind of glue should I use?

Thanks!

Eric

回答がありました！ 回答を表示 同じ問題があります

この質問は役に立ちましたか？

はい いいえ
スコア -1
コメントを追加

1 件の回答

フィルタ：
参考になった順 新しい順 古い順
ベストアンサー

オプション

Do you mean the two sockets are detached (desoldered) from the logic board and are now at the end of the cables ? If so I don't think that any glue could restore an electrical connection from the socket to the board.

Could you upload picts of the connectors ?

このアンサーは役に立ちましたか？

はい いいえ
スコア 1

3 件のコメント:

Well, I'm afraid that's what I did - the sockets are detached from the board. When I looked again at the connectors, I understood what I *should* have done.

Is there any hope repairing this? (It's not the only problem with the MacBook).

さんによる

Sorry but if you go to any Apple dealer for such a repair they will only quote you for a logic board replacement cause they don't repair boards at component level. You may try to find an electronic shop that would resolder the cables directly to the logic board or use special reflow method to attach the sockets to the board.

さんによる

Thanks for the answer!

I was actually lucky with that repair: a friend of mine managed to resolder the sockets to the logic board, now the MacBook runs again.

さんによる

コメントを追加

回答を追加する

Eric Fehse さん、ありがとうございました！
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 1

今までの合計 2,365