評価: 1
2
I am working on an iPhone 4 and a little confused. The phone got slightly wet and shut down yesterday. Since it has not powered. I replaced the battery and dock port with same results but if I take the logic board and put it into known good phone it powers right up. What would be my next step here?
この質問は役に立ちましたか？
評価: 782.2千
1.1千
893
2.3千
wurmy1, my suggestion is that you clean your iPhone before any corrosion will further damage your phone. Use this guide to accomplish that. It was written for a 3G but applies to your phone as well. When you transfer your logic board to another phone, and it powers up, take a look at what parts you do not transfer. Since it works in another phone, the part that does not get transferred is the culprit.
このアンサーは役に立ちましたか？
評価: 361
5
1
1
Take the phone apart and set the parts in dry rice over-night. It should absorb the rest of the moisture that is left in the phone. Then try putting the phone back together and see if that helps.
このアンサーは役に立ちましたか？
過去 24時間: 0
過去 7 日: 0
過去 30 日: 0
今までの合計 501
