Touchscreen works badly after installing new front panel

Question

iPhone 3GS

より早い処理スピードを可能にしたiPhone 3Gのアップグレード版です。このデバイスの修理は3Gと似ており、標準のドライバーと開口ツールが必要です。モデル番号 A1303 / 16 もしくは 32 GBの容量 / ブラックもしくはプラスチックの背面ケース

1500回答すべてを表示

Lena @lena70447

評価: 1

投稿日: 2012年4月16日

オプション

Touchscreen works badly after installing new front panel

(Iphone 3GS 16 GB)

Hey,

i removed my broken touchscreen few days ago and installed a new one, using the instructions on ifixit.com. At first sight it looked like everything was working but then i found out the bottom part of the touchscreen doesn't react. The upper sector does react, but not even nearly as good as my original one before ( even in broken condition).

I wonder what's the reason...

Guess it may be hard to analyze the problem without seeing the phone but If i'd demaged something just as the ribon cable 2 would the touchscreen work partly just as it does ?

I used a quiet cheap front panel so could this be the only reason for the faulty ?

Would be so great if you'd tell me your expections, because i just don't know if it would make sense to buy a high quality panel and install it.

Thanks!

この質問に回答する同じ問題があります

この質問は役に立ちましたか？

はいいいえ

スコア -1

コメントを追加

2件の回答

Xile @xile6414 評価: 931 8 5 1 · Answer 1 · 2012-04-18T08:19:58-07:00

最も参考になった回答

Xile @xile6414

評価: 931

8

5

1

投稿日: 2012年4月18日

オプション

The only times I have had this issue either:

- The connector wasn't fully engaged and just needed popping off and re-seating

- Small tear in the cable for the connector

- Bad part

there is a slim chance that the connector on the logic board itself was damaged in the original incident but I think I've only seen 1 phone with this issue and I put it down to a DIY fix gone wrong.

このアンサーは役に立ちましたか？

はいいいえ

スコア 2

1件のコメント:

Lena, sounds like a bad digitizer. Contact your vendor and see if they are going to replace the one you have.

oldturkey03 さんによる2012年4月18日

コメントを追加