修理を始めるには コミュニティ ストア

Sony Computer Entertainmentによって製造されたPS4と通称で知られるテレビゲーム用コンソールです。2013年2月20日に製品の発表、2013年11月15日に発売されました。

1696回答 すべてを表示

オプション

Power supply connector ripped off CUH-1206B

Hello! I messed up.

In the attempt of changing my PS4's (fat with physical buttons CUH1206B) thermal paste and pads, I ripped off the power supply connector in the motherboard. Below are some images.

The motherboard with ripped pads:

Block Image

Block Image

The connector:

Block Image

The connector place in it's proper position on the board:

Block Image

I have never messed with soldering, but I do intend to try fixing it as buying another PS4 is just impossible for me right now, so the simpler the solution, the better. I'm following other tutorials on this but I can't seem to figure out where the traces for the upmost left connector go, any ideas?

Thanks in advance, this console is very important to me and the moment I'm living.

この質問に回答する 同じ問題があります

この質問は役に立ちましたか？

はい いいえ
スコア 1
コメントを追加

1 件の回答

フィルタ：
参考になった順 新しい順 古い順
最も参考になった回答

オプション


***arthurc.victor darn tore the solder pads off too. Well, you will need to solder some jumpers. See the attached image. You wil need to scrape the green masking off. Use a thin sharp object for that. I prefer a scalpel (available at plenty of places like hardware stores/feed stores and department stores). Then get yourself some enamel wire and solder the connection to the points on the board. Your connector will be pretty loose, I would use some good adhesive (no, not crazy glue) and adhere it to the board. Since you have never done this, practice on an old board first. It's not as easy as it looks :-) if you have never done it.

Block Image

***

このアンサーは役に立ちましたか？

はい いいえ
スコア 1

5 件のコメント:

Thank you for the help, but I have one doubt: the yellow dot would be ground? As in, just scrape the board and solder. And the purple line, should I solder to that square right next to it? Don't wanna risk frying the board, thanks again.

さんによる

The red line, I’d just solder to the trace right next to it and not all that way. Neater too.

さんによる

@strongbow i thought about that as well but went the path of least resistance. It’s a PITA to solder on that small trace :-) old eyes and shaky hands need a bigger connection point. ;-)

さんによる

@arthurc.victor yes you can solder right on that pad. I just wanted to mark the general area for that

さんによる

@oldturkey03 I'm thinking microscope so it would be massive lol. Which ever would be easiest to get it working again. 👍

さんによる

コメントを追加

回答を追加する

arthurc.victor さん、ありがとうございました！
統計データ:

過去 24時間: 0

過去 7 日: 1

過去 30 日: 6

今までの合計 350