修理を始めるには コミュニティ ストア

A washer series by Maytag with a low rate of customer satisfaction and a high rate of failure. These washers have the model numbers MVWB300xxx or MVWX300xxx.

213回答 すべてを表示

オプション

Won't run a cycle after replacing the lidlock.

Bravos 300 top-load washer: MVWB300WQ0

After replacing the lidlock, I buttoned everything back up and plugged the washer in. Aha! Regular startup screen. Chose the drain and spin cycle, display showed 14min as usual. Pressed start. Heard the magnetic lidlock engage and the light came on. Cycle never began. I then pushed cancel. After that, any button I push, or turn of the knob , causes a beep. Display no longer showing anything. I unplugged the washer, waited 5 min and tried again. Same scenario.

I've checked several sites and looked through all of the appliance assistant pages. Nowhere can I find what the consistent beeping signifies. Anyone know?

この質問に回答する 同じ問題があります

この質問は役に立ちましたか？

はい いいえ
スコア 0
コメントを追加

1 件の回答

フィルタ：
参考になった順 新しい順 古い順
最も参考になった回答

オプション

Hi @momac

The beep is an indication that the lid is not detected as being closed, even though you've heard the lock operate.

Here's the tech sheet for the washer.

Go to Test #8 Lid Lock on p.6 to check if the lid lock, lid lock circuit is OK

このアンサーは役に立ちましたか？

はい いいえ
スコア 1

3 件のコメント:

Thanks jayeff. I'll give it a try.

さんによる

Where can I get a diagram to reference the p# connectors?

さんによる

@momac

See p.15 of the tech sheet.

Usually the connector pin number is shown on the board, either by the number 1 at one end of the connector or perhaps an arrowhead

さんによる

コメントを追加

回答を追加する

Tof McWilliams さん、ありがとうございました！
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 6

今までの合計 95