メインコンテンツにスキップ

Model番号 A1225 / Mid 2007とEarly 2008 / 2.4, 2.8もしくは3.06 GHz Core 2 Duoプロセッサ

432回答 すべてを表示

iMac 2007 24 inch changeable with the 20 inch?

Hi all,

So I have a dead iMac from 2007 (24 inches) and I'm getting a 20 inch one for free. Of course, the 24 inch screen is nicer, so can I put the 20 inch computer inside the 24 inch case and use the screen from the 24 inch?

Thanks in advance

この質問に回答する 同じ問題があります

この質問は役に立ちましたか?

スコア 0
2 件のコメント

Depending on the exact 20" model you might be in luck.

さんによる

It's a 2007 model as well.

さんによる

コメントを追加

2件の回答

最も参考になった回答

As you can see here the logic boards are very similar!

iMac Intel 24" EMC 2134 Logic Board

iMac Intel 20" EMC 2210 Logic Board

The layout is the same, I'm suspecting its doable. I personally haven't done it but it would be a fun exercise to try!

iMac Intel 20" EMC 2210 Logic Boardの画像

製品

iMac Intel 20" EMC 2210 Logic Board

$44.99

iMac Intel 24" EMC 2134 Logic Boardの画像

製品

iMac Intel 24" EMC 2134 Logic Board

$34.99

このアンサーは役に立ちましたか?

スコア 1

8 件のコメント:

@danj which power supply would I use? Or would I use both? I'm assuming that the 20 inch power supply is less than the 24, but not compatible? I'm sure there would be lots of space either way

さんによる

@gaussymousy - You're just swapping the logic board correct? Thats all you should need to do.

さんによる

@danj Yes but I still need a power supply right? Not sure if I can use the 24 inch imac's power supply in my 20 inch board.

さんによる

@gaussymousy - I'm not sure I'm following you here. The 24" iMac power supply can be used.

さんによる

@danj Ok so i've decided not to do the swap, but after I opened the 20 inch iMac, the cpu fan now goes on full blast. I've done all the resets, and checked the cables (Though for some reason if I power it up while the bezel is off, no fans) The fan goes to full about halfway through the apple logo. No fan control software is installed.

さんによる

3件以上のコメントを表示

コメントを追加

First you need to discern why the 24" is not working. Probably the power supply. Take a look at the diagnostic LEDs on the logic board and tell us what you see.

このアンサーは役に立ちましたか?

スコア 0

2 件のコメント:

@mayer The optical drive makes the startup sound, but there are no other indications of life. As far as the LEDs go, the first three are on, but the last is not.

さんによる

The 3 LED lights shows power supply and logic board are good. On this model your most likely failure is the video inverter.

さんによる

コメントを追加

回答を追加する

Gaussy Mousy さん、ありがとうございました!
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 1

今までの合計 103