メインコンテンツにスキップ

より早い処理スピードを可能にしたiPhone 3Gのアップグレード版です。このデバイスの修理は3Gと似ており、標準のドライバーと開口ツールが必要です。モデル番号 A1303 / 16 もしくは 32 GBの容量 / ブラックもしくはプラスチックの背面ケース

1500回答 すべてを表示
締切られた回答

Power button doesn't operate after replace of volume button

I replaced the volume button on my iPhone3GS and had to tear the phone all the way to the volume part. I assembled the iphone back and everything seemed to work great but the power button. It clicks but it doesn't operates. Any clues on what went wrong? I'm going back to tear down the phone again to see if I did something wrong which I think I went over the guidelines religiously. Any clues?

回答がありました! 回答を表示 同じ問題があります

この質問は役に立ちましたか?

スコア 0
コメントを追加

1 件の回答

ベストアンサー

pmarin,

I think your idea to take the phone apart again is the best course. These cable connectors can be finicky at best and have certainly been the cause of some customers headaches. While you are re-assembling the phone again, inspect the connectors and sockets to be sure there i no dirt, debris or bent pins. Clean the connectors if necessary with a high content rubbing alcohol (minimum 80%) and just take your time. If the power button was fine before, I'm sure a careful reassembly (and clean if necessary) will set things right. Good luck and let us know how it goes.

このアンサーは役に立ちましたか?

スコア 0
コメントを追加
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 487