メインコンテンツにスキップ

Apple Watch Series 1はオリジナルのApple Watchの改良版で、2016年9月7日に発表されました。 パーツの多くはSeries 2と同じです。

123回答 すべてを表示

Green Snake, Red Snake, Won’t charge

My original Apple Watch s1 battery was expanding and pushed the screen off the body of the Watch. So I replaced it with a battery from ifixit. The watch now shows the red snake when not charging, and green snake while charging. No matter how long it charges.

If I let the watch off the charger for a week or 2, and then charge it, it’ll boot up and work normally for a day. Until it’s time to charge again. The battery continues to drop even while charging on the original apple charger, and then die, and go back to the snakes.

Any suggestions?

この質問に回答する 同じ問題があります

この質問は役に立ちましたか?

スコア 1
2 件のコメント

I have the same problem. After looking online at every video and picture of the battery installed I may have found the answer, but I would need confirmation… the negative and the positive are reversed on the battery ifixit sells as opposed to the OEM. I have purchased 2 now with the same set up. I have pictures but don’t know how to upload them.

さんによる

Make sure there are no tears in your battery cable

I had this issue and that’s what’s caused it:-)

さんによる

コメントを追加

1 件の回答

最も参考になった回答

Sounds to be a faulty battery,

Contact ifixit for a replacement replacement battery

このアンサーは役に立ちましたか?

スコア 2
コメントを追加

回答を追加する

Matt さん、ありがとうございました!
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 2

今までの合計 276