メインコンテンツにスキップ

2.6GHzデュアルコアIntel Core i5プロセッサ(Turbo Boost使用時最大3.2GHz)、3MB共有L3キャッシュ

120回答 すべてを表示

Won't turn on, when I get it on the fans run at full speed.

Block Image

My mac wouldnt turn on so I reset SMC, NVRAM and it still wouldn’t. What got it to boot was unplugging the power supply, pressing the power button then plugging the power cable back in while continuing to hold the power button. After a few seconds the macbook will start but the fans are running at full speed. Everything seems fine except the fan speed, and that If i shut down the computer, i cant start it normally. I have to start it using the steps listed above every time.

この質問に回答する 同じ問題があります

この質問は役に立ちましたか?

スコア 0
コメントを追加

1 件の回答

最も参考になった回答

Let’s do this follow this guide to Step 9 disconnecting the battery MacBook Pro 13インチRetinaディスプレイ(2013年初期)の交換

With the battery disconnected plug in your MagSafe charger the cord LED should be Amber at this point and the system should spontaneously boot up. Once it has lets install CoconutBattery while you can. Now shut down your system and reconnect battery and with the MagSafe charger plugged in it should still be Amber. Now restart your system and let is sit a moment and the run CoconutBattery take a snapshot of the min window and post it here for us to see iFixitでの質問に画像を追加する方法

Update (03/22/2022)

@pathosmusic - Your logic board has problems with the SMC logic. You’ll need to remove the logic board and inspect the other side. Review this image the SMC chip: TI TPS 51980

Block Image

MacBook Pro 13" Retina Display Early 2013 バッテリーの画像

ガイド

MacBook Pro 13インチRetinaディスプレイ(2013年初期)の交換

難易度:

難しい

30 minutes - 2 hours

iFixitの画像

ガイド

iFixitでの質問に画像を追加する方法

難易度:

とても簡単

2 - 5 minutes

このアンサーは役に立ちましたか?

スコア 1

5 件のコメント:

The system did not boot up on its own with the battery disconnected. I had to unplug the charger, press & hold the power button, reconnect the power cable while still holding the power button for another 5 sec. Then it booted with fans at full speed again. I don't think this is a battery issue.

さんによる

@pathosmusic - I'm a bit confused in what you are saying here. Did you get the system to boot up without the battery at all?

さんによる

@danj Yes but it acts the same as when the battery is connected. Can only turn on using the steps above.

さんによる

@pathosmusic - Still lets get that CoconutBattery snapshot with the battery installed.

What we did was reset SMC, that undid the lock nothing more.

さんによる

I uploaded the screenshot, but it doesnt show that the battery is there, or that there is a power adapter plugged in

さんによる

コメントを追加

回答を追加する

Chris さん、ありがとうございました!
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 4

今までの合計 65