メインコンテンツにスキップ

2.26 or 2.4 GHz / White plastic unibody enclosure

645回答 すべてを表示

CPU got hot after applying new thermal paste

Hello.

This past Sunday, I recently applied new thermal paste (Arctic Silver 5) onto my CPU as the former CPU thermal paste was very dry.

After I applied it the CPU temperatures seem to still be hot at idle 50-60 degrees Celsius.

Is it normal for the temperature to be high after applying new thermal paste and then the thermal paste will start working or is there something wrong with the heat sink?

回答がありました! 回答を表示 同じ問題があります

この質問は役に立ちましたか?

スコア 1
コメントを追加

3件の回答

ベストアンサー

I suspect you either put on too much paste (a common fault) or too little.

Also did you clean off all the old paste? I use isopropyl alcohol 99.8% pure to clean.

Remember what you are doing is filling in microscopic pits in the bottom of the heat sink and the top of the CPU. If any squishes out the side as you reinstall the heat sink you have used way too much!

So redo it and see how it goes.

このアンサーは役に立ちましたか?

スコア 3
コメントを追加
最も参考になった回答

Check for a greasy type of residue under the crimped end of the heat sink. If you find it, replace the heat sink as it has probably leaked.

MacBook Unibody Model A1342 Heat Sink Replacement

このアンサーは役に立ちましたか?

スコア 3

5 件のコメント:

Checked it. No oily substance

さんによる

I also noticed when browsing on the internet on safari or watching YouTube videos, the CPU load is 80-100% which makes the CPU temps 40-60 Celsius. Sometimes it causes a battery drain in my MacBook which can go from 100% to 90% in 30 minutes.

さんによる

@Krishay P

Have you scanned for malware? Could be some one is hitching a ride on your system?

さんによる

Scanned for malware and unnecessary files with Malwarebytes. No malware. I checked Activity monitor and it says the task that is the most intensive is kernal_task.

さんによる

Replaced thermal paste. Still idling at 50-60 degrees Celsius and 100% load

さんによる

コメントを追加

Before applying thermal paste you should see how it was done perfectly so you don’t have to bother after applying it.

Here is a youtube video for you

https://www.youtube.com/watch?v=JYwHB2P6...

Also, you should test a performance verification test of your computer from a reliable infotech company

このアンサーは役に立ちましたか?

スコア 0

1件のコメント:

I replaced the thermal paste for a third time. Still running at temperatures between 50-60 at high load (50% or greater). Could it be a problem with the heat sink or the logic board itself or it has an ssd?

さんによる

コメントを追加

回答を追加する

Krishay P さん、ありがとうございました!
統計データ:

過去 24時間: 1

過去 7 日: 10

過去 30 日: 33

今までの合計 2,940