メインコンテンツにスキップ

2017年9月に発売されました。モデル番号はA1863、A1905。GSM もしくはCDMA/容量は64か256GB/ゴールド、シルバーとスペースグレイ

873回答 すべてを表示

Strange fault after Rear case replacement

Hi all,

I repairs phones and tablets regularly. My Dad is an IT tech and ex microelectronics apprentice. He recently had a screen repair on an iPhone 8 which went fine but they also asked for the rear glass to be replaced so he went ahead and replace the whole chassis/rear frame.

The phone will no longer power on. I have done a full teardown and rebuild and I cannot find a single fault.

I have also tried a new battery, however it has been sitting for a long time so I’ve ordered another just incase.

My Dad is extremely careful with pry tools etc, probably more careful than myself who can be a bit ham fisted.

Can anyone think of a reason why the phone will no longer switch on after a rear case replacement? This is really frustrating me trying to work this out and any help would be much appreciated.

回答がありました! 回答を表示 同じ問題があります

この質問は役に立ちましたか?

スコア 0
2 件のコメント

Good news, I have now managed to get the phone to boot. I think I’ve identified the short as the diversity wifi antenna, although I don’t really know why if I am honest.


Now run into another problem where the phone will only charged when switched off. This is a bit of a nightmare phone !

さんによる

Oh thats a new one on me there mate. Sounds like something else is shorting out the charge port when the phone is powered up.

さんによる

コメントを追加

1 件の回答

ベストアンサー

I have a similar issue with a customer iPhone 8 Refurb. Put the motherboard into the new housing and connected the charger flex and nothing. But if I install the flex outside of the housing just to test phone boots.

I am unsure myself on whats the issue but I am assuming the housing is shorting somewhere. I wonder if you have the same issue :)

Try it with the bare minimum in the housing, Charging Flex, Logic Board, Battery and Screen. Try to power up without the charging flex connected then try with it connected. If it boots add parts one by one till you find the issue

このアンサーは役に立ちましたか?

スコア 1

2 件のコメント:

Thank you, that sounds perfectly reasonable and pretty much the only logical answer. Have you tried another housing?

さんによる

I am awaiting my supplier to send another. I will happily reply back if I find anything else out, But I would seriously suggest going with he bare minimum and working your way up to a fully built phone testing after you add each component

さんによる

コメントを追加

回答を追加する

Allan O'Brien さん、ありがとうございました!
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 1

今までの合計 30