メインコンテンツにスキップ

2020年4月に発表、発売された第二世代iPhone SEの修理と分解情報です。

236回答 すべてを表示

iPhone dies at 50% turns back on with 10%

My SE has been dying at 40-50% but when I plug it in to turn it back on, it says I have 10% battery.

A restore did fix this for a couple of weeks but it is happening again.

この質問に回答する 同じ問題があります

この質問は役に立ちましたか?

スコア 3
コメントを追加

2件の回答

I would recommend that you follow the steps in this article to calibrate the battery algorithm.

このアンサーは役に立ちましたか?

スコア 0

5 件のコメント:

The issue with this method is that it says the phone has to be off when you plug it in and then you let it charge to 100 while it’s still turned off.

My phone will be dead, but when I plug it in, it automatically turns on and shows it at 10%.

さんによる

I will look into it

さんによる

Just continue letting it charge until it gets to 100%, Tell me if that works.

さんによる

Doesn’t work. Phone dies at 50% still. Going to get it replaced via Apple care +

さんによる

That was what i was going to suggest next.

さんによる

コメントを追加

I would suggest battery replacement, During a battery's lifetime it's peak voltage and capacity decline. The charge sensor is not built to register the decline in power and after around 2-5 years the battery cannot provide the required voltage, causing the phone to power off. After this, because of the voltage decline (how batteries percentages are measured) the phone assumes that it has much less charge than than it actually contains

Hope This Helps :)

このアンサーは役に立ちましたか?

スコア 0
コメントを追加

回答を追加する

wyo_ さん、ありがとうございました!
統計データ:

過去 24時間: 5

過去 7 日: 18

過去 30 日: 47

今までの合計 2,685