メインコンテンツにスキップ

2012年11月2日に発売された第四世代のiPadです。16、32、64GBモデルがあります。モデル番号はA1458です。

217回答 すべてを表示
締切られた回答

digitizer n ot working after replacement

Hello everyone, i got into my hands a ipad 4th generation from another shop that came in for digitizer replacement that stop working after a new one was installed i asked the tech if he used metallic tweezers or screw driver to disconnect the cables from the connector, he said yes so i would know where to start looking since he already check connectors and tried other new digitizers.

im new in micro soldering and i like to get deep into board level repair and most (80%) i find the problem (hopping to get better 95% at least)

i found out the following: not voltage in U3101, R3107, R3120

i followed the voltage supply to the following chips and replaced them but no luck: U300, U3007, U3009, U3010 and the digitizer driver IC U3101

all of those ICs have not voltage, if someone can help me find the problem i will appreciate it, thanks

この質問に回答する 同じ問題があります

この質問は役に立ちましたか?

スコア 0
コメントを追加

1 件の回答

最も参考になった回答

Is there any components knocked off the logic board.

このアンサーは役に立ちましたか?

スコア 1
コメントを追加
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 16