メインコンテンツにスキップ

モデル番号A1311 / Mid 2011 / 2.5 & 2.7 GHz Core i5もしくは2.8 GHz Core i7プロセッサ

430回答 すべてを表示

Black Screen after changing thermal paste

IMAC 2011 21.5 EMC 2428

It was working perfectly.  It was opened to change thermal paste.  Now it turns on but the screen goes black after a few seconds the fans accelerate.  

The diagnostic LEDs light up the 4.

 Apparently there was no error in the assembly or damage to any cable or board.

 the machine had no problem with the video card before

 After reassembly, he presents this symptom.

 Only the thermal paste of the processor was changed.

The video card has not been tampered with.

 Do you have any tips or details that I may be missing?

この質問に回答する 同じ問題があります

この質問は役に立ちましたか?

スコア 0
コメントを追加

1 件の回答

最も参考になった回答

More often than not, you likely didn’t mount the CPU correctly. You’ll need to pop is off again to make sure the socket pins are not damaged and when you remount the heat sink make sure you slowly tighten the screws in a cross pattern like you do for changing a tire rim, tighten each screw in a star, or criss cross, pattern.

このアンサーは役に立ちましたか?

スコア 2

2 件のコメント:

the screws on this heatsink seem to be wrong, they don't seem to want to screw in the normal way. Before reading your comment, I took apart everything and retained the heatsink screws again, this time without tightening them too much. I reassembled everything and it worked again.

さんによる

@friedericham - If you're set don't forget to accept the answer - Thanks!

さんによる

コメントを追加

回答を追加する

friederich.maiochi さん、ありがとうございました!
統計データ:

過去 24時間: 0

過去 7 日: 1

過去 30 日: 5

今までの合計 259