修理を始めるには コミュニティ ストア

Mid 2010 Model A1278 / 2.4 もしくは 2.66 GHz Core 2 Duoプロセッサ

794回答 すべてを表示

オプション

Locating a Damaged SMD Component

Hi

Im repairing my a1278 logicboard due to water damaged. Ive found out that the airport card and bluetooth card module were not working. Ive replaced both and only the bluetooth works.

The laptop works ok except keyboard backlight, ethernet port and airport. If I can locate what's the name of this IC, on picture below, I can go futher. I do have a schematic manual of the a1278 but I'm trying to get used to it. See picture:

Block Image

I have all the tools to repair liquid spills but this IC I need to replace. Ive tried a digital camera but the number is not clear.

この質問に回答する 同じ問題があります

この質問は役に立ちましたか？

はい いいえ
スコア -1
1件のコメント

How did you get ahold of a schematic manual? can you point me in the right direction?

さんによる

コメントを追加

2件の回答

フィルタ：
参考になった順 新しい順 古い順
最も参考になった回答

オプション

I have one here that says LDPR on the top line and underneath it says 060I.

I recommend using a heat pump to replace this chip. I hope you have flux as well. You might need to bring the temperature up to 350C to get the component off.

このアンサーは役に立ちましたか？

はい いいえ
スコア 1
コメントを追加

オプション

my problem is in the same area. however the chip below it may be the culprit as it gets hot! ive also noticed in place of where you are pointing in the picture the component below is a small black resistor where my board has a fat silver rectangle with black on top and some writing that is burnt off. could the ic you are replacing have anything to do with that chip getting to hot?

i need to know what this chip is and if i can buy it somewhere to replace.

このアンサーは役に立ちましたか？

はい いいえ
スコア 0
コメントを追加

回答を追加する

Daveyon さん、ありがとうございました！
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 1,022