メインコンテンツにスキップ

2016年9月16日に発売。モデル番号は1660, 1778で GSM かCDMA があり。/ 32、128、 256 GB / 色はローズゴールド、ゴールド、シルバー、ブラック、ジェットブラック

2003回答 すべてを表示

Micro soldering Audio IC for iPhone 7

Hello, my question is regarding the iPhone 7’s Loop Disease. For any micro soldering geeks here on iFixit, here is my question for you: If I buy the soldering workstation on iFixit, does it have everything I would need to get the job done (besides needing a heat gun)? Thanks!

回答がありました! 回答を表示 同じ問題があります

この質問は役に立ちましたか?

スコア 0

コメント:

Maybe @imicrosoldering can help me?

さんによる

Or maybe @refectio

さんによる

コメントを追加

1 件の回答

選択されたソリューション

To do an Audio IC repair, you need both the soldering station and hot air station. The hot air station will allow you to remove, reball and solder the audio IC in place. The soldering station will allow you to make the micro-jumpers necessary to complete the repair. Of course, you can get the Quick Hot Air Station which is really good but much less expensive than the Hakko. However, for the soldering station, I highly recommend the Hakko.

Of course, you also need flux, solder, tweezers, various consumables for cleaning etc.

This is a considerable investment in cash but also time, don’t do your first micro-soldering repair on an otherwise good device…not to mention that the Audio IC is a deceptively difficult repair with plenty of gotcha’s that can turn your phone into a brick. If you do this, get some dead or iCloud locked phones and practice a lot first.

Hot Air Rework Station Hakko FR-810B-05の画像

製品

Hot Air Rework Station Hakko FR-810B-05

$849.99

Hakko Microsoldering Starter Bundleの画像

製品

Hakko Microsoldering Starter Bundle

$799.99

このアンサーは役に立ちましたか?

スコア 3

コメント:

Wowee!!! I’m 13 and I was wondering if I could get all my equipment on Christmas of this year, I guess maybe not if it’s going to be 800$ haha! Anyway, @refectio, if I were to get the 50$ ifixit set and a cheap heat gun, would it be possible to do, like, a very barebones, but working repair?

さんによる

Minho is absolutely right and as for the station on ifixit I don’t think it is suitable for microsoldering. If it is the one I am thinking of it has no heat control and the tip looks far too large to solder micro jumpers which are required for the audio IC. You don’t need something expensive a cheap solder/rework station will do the job. Just make sure you can buy accessory solder iron tips for it.

If you don’t want to spend much money something like this is all you need it is available from Digikey. Part number 2260-AO888A-ND

さんによる

コメントを追加

回答を追加する

Caleb Topper さん、ありがとうございました!
統計データを表示:

過去 24時間: 0

過去 7 日: 4

過去 30 日: 7

今までの合計 129