メインコンテンツにスキップ

修理を始めるには

修理する権利

ストア

食器洗浄機の修理と解体ガイド

397の回答 すべてを表示

not sure if my washer is fully completing the cycles

Thanks for the head up...I was able to get my whirlpool dishwasher in diagnostic mode thinking that would reset. I don't understand how to see and understand the codes anyways (even looked at the tech guide) but don't think that's my problem. Now my problem...if you or anyone sees this post...is that I'm not sure if my washer is fully completing the cycles, since I don't get the clean light on even though all appears to be clean. Also, which is what made me start to look into this, the start/resume light never goes on, even when running or if I open during a cycle....but the washer seems to work anyways. One thing I did notice putting the washer in diagnostic mode (the 123...thing), all lights, even the clean light, go on, except the start/resume light. Any thoughts...could that light or connection just be out, or should a reset (turning off the circuit braker?) be done and could address?

回答がありました! View the answer 同じ問題があります

この質問は役に立ちましたか?

スコア 0
コメントを追加

1 件の回答

選択されたソリューション

Rick, it could be a problem in the communication tape from the user interface or in the PCB why start light won’t come on. Is the dishwasher washing and draining properly now? Are the dishes clean and dry? If so, I wouldn’t worry about the light.

この回答は役に立ちましたか?

スコア 1
コメントを追加

回答を追加する

rick さん、ありがとうございました!
統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 1

今までの合計 8