メインコンテンツにスキップ

2018年3月に発売されたiPadの第六世代モデルです。32もしくは128GBのストーレッジオプション付きのWi-Fi あるいはLTEモデルが選べます。 64ビットA10チップと9.7インチRetinaディスプレイを搭載しています。

220回答 すべてを表示

Trying to unmount iPad 6

I have bought an ifixit kit in order to unmount my iPad 6 (it got wet so I’m trying to dry it out properly to see if I can fix it).

The problem is that I’m really struggling lifting the screen. I use the warmed up iOpener and after some time, I try to lift it with the sucking thing (don’t really know the name of it) but I’m not getting anywhere…

Any advises/tricks/techniques that I can apply?

Thanks! :)

回答がありました! 回答を表示 同じ問題があります

この質問は役に立ちましたか?

スコア 0
コメントを追加

1 件の回答

ベストアンサー

A factory sealed iPad can be quite difficult to open. The iOpener does apply heat but not as effectively as a good electric heating pad. Personally I’ve never used the iOpener so I don’t want to speak out of turn. When I started repairing iPads, I used a MagicBag (hot compress) as that had the advantage of covering the whole iPad.

The trick to these bags is to heat it up, apply to the device and re-heat it again before it cools off. Try this a few times in a row on the same edge (for the iPad 6, the left edge) to get the maximum heat transfer. Then apply the suction cup and try to get your pick inside and work your way from there. Some techs use flat razor blades but I don’t recommend that for noobs (no offense ;-).

My personal favourite is the iFlex for getting in under the glass and then the iPlastix to slide it along as it doesn’t damage the glass. I use the iFixit picks to maintain the gap as I go around the glass.

You may want to check this After doing my repairs (battery and screen) I have problems for when you get to the closing and sealing of the iPad. There are quite a few gotcha’s that aren’t covered in the iFixit guides.

このアンサーは役に立ちましたか?

スコア 2
コメントを追加

回答を追加する

Juan Jose Rebollo さん、ありがとうございました!
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 29