メインコンテンツにスキップ

2016年9月16日に発売。モデル番号は1660, 1778で GSM かCDMA があり。/ 32、128、 256 GB / 色はローズゴールド、ゴールド、シルバー、ブラック、ジェットブラック

2264回答 すべてを表示

Can I disconnect battery cable while the iPhone 7 is on

I’m trying to repair an Iphone 7 that suffered a cracked screen and then water damage. I replaced the battery and tried to boot it up and its now stuck on a black screen with apple logo. I want to try replacing the screen now but I’m now stuck on this screen.

  1. will replacing the screen fix this apple logo stuck screen?
  2. How can I fix the apple stuck screen logo?
  3. Do I need to wait for the battery to drain, or can I just disconnect the cable from the phone to the battery?
この質問に回答する 同じ問題があります

この質問は役に立ちましたか?

スコア 0
コメントを追加

2件の回答

You can disconnect the battery from the phone and it won't hurt it. Just don't disconnect the screen until the battery is disconnected. Changing the screen will not get rid of the apple logo. It's in a boot loop. It most likely has a problem from water damage. The problem is once they are wet they have problems for the rest of there lives IF you can get them working again. Most repair shops won't even work on them except to retrieve data when they are water damaged. If you want to try to fix it you need to pull the board out and remove the covers and see how bad it's corroded. Save the covers for the chips in case you can get it working. Once it gets wet it starts corroding and it does it faster if it has power connected to it. Did you try to charge it after? The first thing you should have done is open the phone and disconnect the battery and pull the board out and remove the covers on the motherboard and dry it off with a heat gun or hair dryer. Then clean any corrosion with a qtip and alcohol. See how bad it's corroded and you might try cleaning the board and see what happens.

このアンサーは役に立ちましたか?

スコア 0
コメントを追加

So I accidentally disconnected the screen before disconnecting the battery now my phone won’t turn on prior to this I replaced the charging port it turned on but my touch sensor wasn’t working so I disconnect the screen instead of the battery first what should I do I have a fresh screen coming in within a couple days but I’m worried that my battery is screwed or my board in general please help

このアンサーは役に立ちましたか?

スコア 0

3 件のコメント:

Don’t panic. I’ve made that mistake numerous times. It rarely does damage unless you touch a metal tool etc on the connector of the board. If you investigate closely you may see damage to the 2 ribbon cables on the screen.

さんによる

Panicking makes the work 1000x harder I’ve learnt the hard way. Try to stay calm and remember that the vast majority of the time the issue caused can be fixed fairly easily.

Also, note that it may take a bit longer to boot

さんによる

As long as you disconnected the battery BEFORE reconnecting the screen it should be OK. If not you've blown a back-light filter.

さんによる

コメントを追加

回答を追加する

derek さん、ありがとうございました!
統計データ:

過去 24時間: 0

過去 7 日: 4

過去 30 日: 15

今までの合計 868