メインコンテンツにスキップ

モデル番号A1502 / 2.4, 2.6, 2.8 GHz デュアルコアIntelプロセッサ/ 2013年10月発売

551回答 すべてを表示

MacBook not starting most of time with sleep light on & stuck at boot

Macbook pro won't start even with external bootable harddrive . Chime could be heard upon switching on ,then goes to sleep …sometimes it gets on but stuck at apple logo while booting … please help

この質問に回答する 同じ問題があります

この質問は役に立ちましたか?

スコア 0
コメントを追加

2件の回答

最も参考になった回答

The following below does not apply to the A1502 13” Macbook Pro Retina so ignore this answer.

When it works does it stop working after putting the Mac to sleep and waking it up? Closing and opening lid for example.

It sounds like the graphics mux chip needs to be reflowed and desoldered. Note that this is not a graphics chip but a chip behind the ball that tends to get loose soldering due to its placement and lead free solder.

Resoldering with leaded solder will fix the connections on that chip and fix the problem if it is being caused by that.

A reputable MacBook repair store that does micro soldering should be able to fix this for you.

Edit: The chip I am referring to is U8900 for the graphics mux chip that provides voltage to the GPU.

このアンサーは役に立ちましたか?

スコア 1

5 件のコメント:

I think you are correct in your assessment . I just checked one cable with a chip coming out near side of a battery . I just hope ,this will solve the issue...

さんによる

It was working normally .coming out of sleep perfectly.. then it started going into sleep after chime .. . Then after so many attempts it starts booting up but getting stuck at same level of progress bar ..

さんによる

The chip I am referring to is U8900 for the graphics mux chip that provides voltage to the GPU.

さんによる

@benjamen50 I usually resolder these chips too Ben but I thought they were only on the 15” model.

さんによる

Oh silly me yes you are right it's the A1398 15" only.

さんによる

コメントを追加

You’ll need to disconnect the battery following this guide to Step 6 MacBook Pro 13インチ Retina Display Late 2013 のバッテリーの交換. with nothing plugged in press the power button holding it for a good minute. Then carefully place the system on its side so you can plug in the MagSafe charger and can see the internal display. Did system boot up on its own and show the Apple logo and progress bar?

このアンサーは役に立ちましたか?

スコア 0

2 件のコメント:

No it's just start chime while connecting the magsafe charger then sleep light turned on. ..after removing battery

さんによる

Well you clearly have a logic board failure ;-{

At this point I think you'll need to either find someone with the needed deeper skills to fix your logic board or replace it.

さんによる

コメントを追加

回答を追加する

Tuppup さん、ありがとうございました!
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 84