修理を始めるには コミュニティ ストア

Wi-Fi付きの初代Apple iPadは16，32，64GBから選べます。モデル番号はA1219。修理は複雑な作業はなく、ヒートガンなどは不要です。

130回答 すべてを表示

オプション

Why can't I get the metal spudger between frontpanel and the rear?

Hi,

I need to replace the front panel of my Ipad. My wife dropped the IPAD and the glass cover is completely shattered, but the IPAD is still operational.

I got all the necessary specialised tools and components, downloaded your repair guide and watched the video for this specific repair job.

I can't get the metal spudger (sold to me as the original IPAD opening tool) between frontpanel and the rear casing without damaging the rear casing.

Obviously I must be doing something wrong.

Please advise.

回答がありました！ 回答を表示 同じ問題があります

この質問は役に立ちましたか？

はい いいえ
スコア 0
コメントを追加

3件の回答

フィルタ：
参考になった順 新しい順 古い順
ベストアンサー

オプション

First, you should have at minimum two spudgers, but three to four is optimal. Make sure to start on the right side to get the tabs out. If using a wide spudger the damage to the housing will be minimal. I am able to get into an iPad without leaving a trace - so it is possible. Plan ahead and purchase ten spare clips as those break easily and are cheap. Also purchase spare pads so the replacement screen doesn't sit lower than the housing.

このアンサーは役に立ちましたか？

はい いいえ
スコア 0
コメントを追加

オプション

In fact, I think there's no way to open the iPad without breaking something.

I've damaged a little the inner plastic frame of the display and many plastic flaps (used to keep the display inside the case) broke off.

このアンサーは役に立ちましたか？

はい いいえ
スコア 0
コメントを追加

オプション

Hi ,

I also had some problems opening the Ipad, but in the end it worked. I had to replace the flaps. I just a plastic tool :)

Did you replace the screen with succes? because I didn't.

このアンサーは役に立ちましたか？

はい いいえ
スコア 0
コメントを追加

回答を追加する

toine さん、ありがとうございました！
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 1

今までの合計 1,072