メインコンテンツにスキップ

Repair guides and support for all-in-one washer and dryer assemblies as well as stacked units.

139回答 すべてを表示

I over loaded my washer and it overflowed and won’t get any power..

I stuffed a huge blanket in the washer and I guess it made the water overflow. There’s water on the floor but not that much. But the power is out on the unit completely. The washer and the dryer. I tried resetting the electricity breaker switches for the laundry room but still nothing. I don’t know what else to do…

この質問に回答する 同じ問題があります

この質問は役に立ちましたか?

スコア 0
コメントを追加

2件の回答

最も参考になった回答

Hi

What is the make and model number of the washer / dryer combo unit?

Did it trip the breakers or did you just reset them both (turn off / turn on)?

It may be that the water caused an electrical problem with the washer / dryer’s control board.

With the power totally disconnected from the washer, open up the washers control panel and check for any obvious damage to the control board e.g. burn marks, blown components etc.

If you spot any damage (or even if you don’t) and are not quite sure, take some close up pictures of the board and post back here.

Here’s how to do this.

iFixitでの質問に画像を追加する方法

このアンサーは役に立ちましたか?

スコア 1
コメントを追加

Are these connected to a GFCI Outlet? These are the ones that have the two little buttons on the wall outlet. These are often installed in areas around water such as kitchens and bathrooms. These are designed to work like a breaker but at the outlet level. If you see two little buttons try and press the one that says reset.

このアンサーは役に立ちましたか?

スコア 1
コメントを追加

回答を追加する

Jennifer de la rosa さん、ありがとうございました!
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 2

今までの合計 53