メインコンテンツにスキップ

2016年3月に発売された4インチのiPhone。ハードウェア仕様は6sに類似しています。シルバー、スペースグレイ、ゴールド、ローズゴールドのカラーが揃っています。16/64 GB容量、Model A1662とA1723

1047回答 すべてを表示

Rebooting every 5 or so min when im using it. + microsoldering advice

The battery was definitely dying but im fairly sure ive scraped off the 4 capacitors on top of the battery connector(at least 1). So now for my question: are any of these parts critical, and if so can i use small copper wire or will i need to bring it to a repair store to have the capacitors re-soldered?

Block Image

Also i did this by looking at a very old mastermind child’s microscope so i might just be wrong…

回答がありました! 回答を表示 同じ問題があります

この質問は役に立ちましたか?

スコア 0
コメントを追加

1 件の回答

ベストアンサー

Third component from left to right in the pic you enclosed is a filter and if it’s missing the rail would be interrupted and phone wouldn’t work. If you bridge it, missing connection between ends would be restablished and phone would work if that’s the only problem. That can’t be considered good practice as in case of troubles there wouldn’t be anymore a protecting filter to burn but a bridge to charger circuit components. Ultimate decision is yours. Other pictured components are capacitors, if you bridge any of those you will short the board.

このアンサーは役に立ちましたか?

スコア 2

3 件のコメント:

Ok thanks a lot, i will take it to a small electronics shop and see what they can do... I tried bridging it with my soldering iron and some wire but its too small for my equipment.

さんによる

ok scratch that they don't exist where i live... can i short it with some conductive tape? and is it the only important one there, or will i have to short the others? @arbaman

さんによる

@nineballo There's not much more I can say, I pretty much answered your questions already. You can use whatever it works to shorten the two pads, conductive tape, glue or paste but you're taking your risks.

さんによる

コメントを追加

回答を追加する

NineBall さん、ありがとうございました!
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 38