メインコンテンツにスキップ

iPhoneの第4代目で、修理はそのままパーツを直接交換するだけです。しかし、正面ガラスとLCDはセットで交換する必要があります。容量はGSM / 8,、16m32 GB / モデル番号 A1332 /本体カラーは黒と白色

2375回答 すべてを表示

Swapped home buttons, now phones won’t connect with AT&T

I have two iPhone 4 devices, and two phone numbers. The home button on the phone I use more often (phone 1) was going bad. Yes, I should have just swapped the SIM cards but I didn’t. I swapped the home buttons instead. It went exactly as expected (the good home button, from phone 2, works great on phone 1, and the lousy home button works just as badly on phone 2 as it used to on phone 1). BUT now neither phone will connect with the cell carrier (AT&T). Phone 2 connected with AT&T weakly (one bar) for a few seconds when first powered up after the swap but nothing since). Both phones alternate saying (upper left) “searching….” and “no service.” I tried swapping SIM cards, resetting network settings, toggling airplane mode and cell data, and updating iOS on phone 1. Nothing. Any ideas/guidance much appreciated.

回答がありました! 回答を表示 同じ問題があります

この質問は役に立ちましたか?

スコア 0
コメントを追加

1 件の回答

ベストアンサー

Double check to see if this antenna connector is plugged in which is located right next to the battery connector as shown in this guide:

iPhone 4 のセルラーアンテナの交換

That antenna has a few clips on the loudspeaker housing so make sure those clips are clipped in well into the housing as that can affect antenna performance as seen specifically in step 12.

このアンサーは役に立ちましたか?

スコア 1

1件のコメント:

Yes! I was not careful with these connectors originally. Once I snapped them into place, the phones picked up the cell network, no problem. Thank you Ben! I’m very grateful.

さんによる

コメントを追加

回答を追加する

HTSMatt さん、ありがとうございました!
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 35