修理を始めるには コミュニティ ストア

2016年9月16日に発売。モデル番号は1778,1784。 GSM かCDMAの32、128、256GBがあり、色はローズゴールド、ゴールド、シルバー、ブラック、ジェットブラックがあり。

1364回答 すべてを表示

オプション

Phone no longer vibrates after being repaired

hello, I been having a frustrating time with a customer’s iphone7+.

Customer came for a back housing replacement.

I’ve replaced the back housing however the phone does not vibrate anymore.

the home button does not click however does have touch id.

service carrier works, charging works, phone camera front & back works.

so far i’ve replaced the charger port (twice), the power button & volume button flex cable(twice), factory reset, Taptic Engine(twice).

by twice I mean, using a different part each time.

I have not switch the motherboard to a different housing(i don’t see how this will affect it) but will do soon.

The only available ideas that I have is board repair:

I believe the vibrator driver IC U3502 has gone bad.

この質問に回答する 同じ問題があります

この質問は役に立ちましたか？

はい いいえ
スコア 1
コメントを追加

1 件の回答

フィルタ：
参考になった順 新しい順 古い順

オプション

Hi @darkstaride1

I have had problems like this with the iPhone 7 and 8 charging port replacements. You should check the charging port connector on the logic board for physical damage, then ensure that the alignment is perfect so all the pins make a solid connection.

The best way to ensure the connector alignment is to connect the cable to the logic board, wrap it around underneath the board and tape it against the bottom side. Once you’ve done this, you can put the logic board into the iPhone frame and stick the charging port down where it needs to be to preserve the alignment. After that, you can continue to install the charging port as normal.

Hopefully that will resolve your problem

このアンサーは役に立ちましたか？

はい いいえ
スコア 0
コメントを追加

回答を追加する

Richard D さん、ありがとうございました！
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 3

今までの合計 125