Okay so I know this sounds weird but I just replaced the screen & battery on my iPhone 7 Plus, every screw it's in the right place as I made a diagram and placed every screw where it belongs now here lies the problem, the phone works perfectly when the screen is not placed in the frame but once I put in the screen where it belongs the phone goes in a boot loop unless I take the screen off the phone with the cables still connected. Any ideas? Thanks
評価: 2.1千
11
5
4
Is your frame bent? Apple products can act up when cables get pinched. I have seen this model boot loop when the home button is not connected correctly. It’s possible there is pressure being placed on the home button connector when it’s pushed in.
このアンサーは役に立ちましたか？
I will try putting pressure on the button myself and see if it goes into a bootloop with the screen off
評価: 2.1千
4
4
Check the flex cables especially the small one that goes to right side connector, for the home button if this is getting pinched or damaged then it can be disconnecting the home button or causing a problem with that, if the home button gets disconnected it will usually restart the phone, the flex on the screen may be damaged or the big chip at the back of the screen could be putting too much pressure on something or like suggested the phone could be bent and the pressure of the screen could be causing audio ic issues…
Lay the phone flat on desk face down without the screen connected and with the sim card slot side facing u, look for bends.
このアンサーは役に立ちましたか？
過去 24時間: 0
過去 7 日: 0
過去 30 日: 0
今までの合計 38
