評価: 79
5
2
Hi
i bought a bent iPhone 6 off eBay. I completely disassembled it to un-bend it. I fixed the bend but when I was putting the logic board back in I realised that the top part of it was stuck over a piece of plastic, which had bent it. I removed it again and tried to bend it back but it snapped off. Could somebody tell me if the logic board will still work?
i have attached pictures to show the damage
この質問は役に立ちましたか？
評価: 221.4千
15
289
806
As @pollytintop suggests, the best way to find out is to install it. However, I have looked at the circuit board with ZXW Tools and the only copper trace that runs in that area is for a Test Point. So you should have no issues running the phone properly despite this issue.
このアンサーは役に立ちましたか？
過去 24時間: 0
過去 7 日: 0
過去 30 日: 0
今までの合計 68
3 件のコメント
there's no picture..
pollytintop さんによる
Sorry they’re there now
Shay Mitchell さんによる
should be fine.. I don't think that tiny part has a great significance apart from securing to the housing. I'd try installing it again, it's the only way to find out!
pollytintop さんによる