New display only worked with pressure on connector, now not at all.
Condensed version:
Wife’s iPad screen got broken, and Apple repaired it (non-warranty). New screen worked for a few months, then iPad screen began going black after a few minutes of usage. iPad would stay powered on and had backlight, just no picture.
I ordered a new screen and replaced it myself, same symptoms with new screen (had backlight, no picture). I noticed that if I pressed somewhat hard on the middle of the 3 display connectors, it would display an image on the screen until I removed the pressure.
Thinking there might be dust in the connector, I used 90% alcohol and a qtip to clean the connector, and then blew it out with compressed air. Now I get no picture at all, even when putting pressure on the connector.
Any suggestions, or am I totally out of luck?
この質問は役に立ちましたか?