評価: 45
4
3
I was replacing the Touch IC chip on iPhone 6+ but accidentally broke some pads as seen in images below but to fix these pads I would have to wire it to the other side of the board also seen in screenshots of ZXW tool.
Images:
https://www.dropbox.com/s/uw7q0w5z74ui1o...
この質問は役に立ちましたか？
評価: 221.4千
15
289
806
Sure you can but in order to get the micro-jumper to work properly underneath the IC, you will need some very thin wire. You can source 0.02mm enameled wire from most places that sell micro-soldering supplies. You will also need some UV-curable mask to fix the wire in place so it doesn’t shift around when you heat the IC to install it.
Considering you’re asking the question, I will assume that you are starting out. So my advice would be to practice this on a dead board a few times because if you mess this up, the damage it will cause may become un-repairable.
このアンサーは役に立ちましたか？
Do you know any good video tutorial on how to do this when I have the tools? I am practicing on a icloud locked device which I own so that I can practice this skill with my own board as I would feel terrible if I mess on someone else's.
過去 24時間: 0
過去 7 日: 0
過去 30 日: 0
今までの合計 67
