メインコンテンツにスキップ

2017年11月4日発売。モデルA1865、A1901。GSMまたはCDMA/64GBまたは256GB/シルバーまたはスペースグレイ。(発音は「iPhone 10」と同じ)。

1198回答 すべてを表示

I just replaced the WiFi module of the iPhoneX but still poor

Hello everyone. I just replaced the Wifi & bluetooth module (one piece). However both of these components are still causing issues. I’m getting absolutely dreadful signal for wifi+bluetooth where I can’t discover anything past 2 feet.

この質問に回答する 同じ問題があります

この質問は役に立ちましたか?

スコア 0
コメントを追加

3件の回答

Hi, it sounds like damage to the part of the chip on the Logic Board, caused during the original disassembly of the wifi module. You can try replacing the module you bought to rule out a faulty part, but repair of the chip might involve skilled micro-soldering.

このアンサーは役に立ちましたか?

スコア 0
コメントを追加

UPDATE: i found the culprit. it seems the connector between wifi ribbon cable + logic board is not staying properly. is there a way to keep the connector down and snapped in? right now im trying to tape it down with electrical tape and RTV to mold over it so when the case is pushed down it will stay down but to no avail currently.

このアンサーは役に立ちましたか?

スコア 0
コメントを追加

the center latch part of the wifi connector on the logic board was snapped off or removed or something when it was last repaired ( bought this phone used). i kind of have it taped down, but i am getting a weird reboot loop every few minutes now. I tried a hard shutdown/start, and also did a factory reset - tried setting to dec 1, 2017 etc. nothing works. it does a weird reboot loop, i had it on all night and then tried using it and it decided to start rebooting.

このアンサーは役に立ちましたか?

スコア 0
コメントを追加

回答を追加する

michael stevens さん、ありがとうございました!
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 1

今までの合計 106