I accidentally ripped a flex on the front camera module. I managed to get the flex unsoldered from the sensor. I plan to order a new front camera module and transfer the flex from it. I don't know if it's been done or attempted, but wish me luck.
この質問は役に立ちましたか？
評価: 221.4千
15
289
807
Use low heat and don’t overdo it with the flux as you don’t want it going into the actual camera. I would also practice on a few dead flexes (from less expensive parts) if you haven’t worked on flexes before.
このアンサーは役に立ちましたか？
過去 24時間: 0
過去 7 日: 0
過去 30 日: 0
今までの合計 224
1件のコメント
I wish you the best of luck with the repair! I believe this might be possible but time will tell if it actually is.
[deleted] さんによる