メインコンテンツにスキップ

Repair guides and support for top and front loading Whirlpool brand washers.

305回答 すべてを表示

Whirlppol Washer not spinning

Whirlpool top loader washer model number WTW4800BQ1 will not spin or agitate. After it fills with water the motor will kick on and it it will agitate for like one second and stop. After sitting for a minute it will do the same thing again and then stops. It never proceeds to wash and eventually will drain. I have already replaced the lid switch thinking that was the issue. I went through the diagnostic test mode and it showed F7-E5 and F7-E6 errors. These coordinate to a shifter fault and a motor fault. Since the motor turns I’m guessing shifter issue. Thoughts…

この質問に回答する 同じ問題があります

この質問は役に立ちましたか?

スコア 2
コメントを追加

1 件の回答

最も参考になった回答

Cause 1

Motor Coupling

The motor coupling connects the motor to the washer transmission. If the washer is overloaded, the motor coupling will fail in order to protect both the motor and transmission. The motor coupling can also fail due to normal wear. Inspect the motor coupling to determine if it is broken. If the motor coupling is broken, replace it.

Cause 2

Drive Belt

Inspect the drive belt to determine if it is broken or if it is loose on the pulleys. If the drive belt is broken or loose, replace it.

このアンサーは役に立ちましたか?

スコア 2

コメント:

Coupling was fine.

Drive belt was also fine.

Still thinking it was the shift actuator

Will know for sure tomorrow after I put in a new one in.

さんによる

Replaced the shift actuator (took all of 5 minutes) and the washer is up and running.

さんによる

コメントを追加

回答を追加する

Gary Mckee さん、ありがとうございました!
統計データを表示:

過去 24時間: 0

過去 7 日: 3

過去 30 日: 9

今までの合計 422