評価: 11
3
I just replaced the screen on my SP3. Thanks Ifixit. Process was smooth thanks to your instructions. However now my screen has a dead zone about 2 inches wide across the top. It responds to pen input albeit not 100%. I reinstalled windows 10 to no avail. What am I missing?
この質問は役に立ちましたか？
評価: 782千
1.1千
893
2.3千
any “dead zone” on any touch screen is usually caused by a bad screen. I would suggest that you check with the vendor and replace it. Of course you do want to ensure that the connector is properly seated and the connector are not bend etc.
このアンサーは役に立ちましたか？
Thanks. I just wanted to cover the bases before i went back to the vendor. I will try to post an update.
評価: 11
3
So I decided to do one more search before i contacted the vendor and found something that worked, in the forum. I posted the link below.
My surface is back!
このアンサーは役に立ちましたか？
過去 24時間: 0
過去 7 日: 1
過去 30 日: 5
今までの合計 951
3 件のコメント
@kevranjac Did you buy the screen from iFixit?
[deleted] さんによる
Yes, bought it from ifixit.
Kevin Jacobs さんによる
Thanks. I just wanted to cover the bases before i went back to the vendor.
Kevin Jacobs さんによる