メインコンテンツにスキップ

2014年9月9日に発表されたこのデバイスはAppleが進出した最初の身につけるスマートデバイスです。iFixitの修理マニュアルではApple Watch (スティール製)とApple Watch Sport (アルミニウム)どちらも対応しています。

210回答 すべてを表示

Where should I solder the wireless coil wires?

My Apple Watch wireless charging coil connection is detach from the S1 board and I do know the connection. Can someone advise me where should I solder the wire? I can’t identify the positive and negative of the pad.

Block Image

回答がありました! 回答を表示 同じ問題があります

この質問は役に立ちましたか?

スコア 0
コメントを追加

1 件の回答

ベストアンサー

I’m not an expert with the Apple Watch but if the charging coil is “just a coil”, then it won’t matter which orientation as it will create an inductive field either way.

このアンサーは役に立ちましたか?

スコア 2

9 件のコメント:

While I agree a coil is not polarized I do wonder why one of the wires is colored Red. The few units I did fix had the full bottom unit come off. It appears only the coil came off in yours. You may want to just get the assembly and replace the full part. While more work its more likely to work.

さんによる

@danj If there is any other circuitry inside, then yes polarity will be important. I'm just going on what I can see. Looking at the third picture of Step 20 of this Teardown guide, both wires look black.

さんによる

You'll need the smallest tip you can find, like 0.2mm (smaller is better). Any standard paste flux will work fine.

さんによる

Thanks @refectio . To clarify again, should I buy solder paste or solder flux? How to clear the surface before soldering?

さんによる

@danj is there any wires falling off on the units that you fixed before?

さんによる

4件以上のコメントを表示

コメントを追加

回答を追加する

Hu Wei Ng さん、ありがとうございました!
統計データ:

過去 24時間: 0

過去 7 日: 2

過去 30 日: 7

今までの合計 509