メインコンテンツにスキップ

2016年9月16日に発売。モデル番号は1660, 1778で GSM かCDMA があり。/ 32、128、 256 GB / 色はローズゴールド、ゴールド、シルバー、ブラック、ジェットブラック

2264回答 すべてを表示

iPhone 7 over heating, no service, won't charge after screen replaced

I had an iPhone 7 that needed the screen replaced after it was shattered. I replaced the screen and everything was functioning properly after. In a very short period of time the battery drained, the phone had no service, the phone was warm to the touch and it could not be charged. I put the old screen on and everything was fine. I tried another screen and had the same issues. Two bad screens or might something else be going on? Has anyone had this issue before?

この質問に回答する 同じ問題があります

この質問は役に立ちましたか?

スコア 0
コメントを追加

2件の回答

最も参考になった回答

Have you tried doing phone calls on the phone after the screen replacement to test the hardware on the front camera such as:

  • Top microphone (used when speaker phone is activated)
  • Earpiece (Hear during calls)
  • Proximity Sensor (Face detection to turn off screen when phone is put near your ear)
  • Automatic Brightness (Phone adjusts brightness accordingly depending on your environment (sunlight))
  • Front Camera

If any of these are faulty they can be the cause of the phone heating up a lot and rapid battery drain indicating one of those things are causing a short circuit resulting in abnormally high power draw.

Another thing to check, can you read the IMEI and modem firmware in settings > general > about phone? And also the IMEI displaying when typing *#06# in the phone dialer?

このアンサーは役に立ちましたか?

スコア 3

1件のコメント:

The phone wouldn't stay on long enough to test more than the touch and camera which were working fine. After thinking about the reason it was powering off to begin with, I think it was doing that as a safeguard because it was getting too hot. As soon as I put the original screen back on all of the function was normal, it was not over heating, charging came back, cell service was fine. It was very bizarre and I've never had this happen before. Two replacement screens and neither of them worked correctly. I'm waiting for another 7 to come in to test those screens to see if this happens again. If it does I then know it definitely is the screens and not the phone.

さんによる

コメントを追加

It must be the battery ribbon, change the ribbon or unplug it and plug it

このアンサーは役に立ちましたか?

スコア 0

1件のコメント:

I tried replacing the batter. Still didn’t work. Thank you though. Maybe when she dropped it something happened with the motherboard. I don’t go there.

さんによる

コメントを追加

回答を追加する

Kelli McDonald さん、ありがとうございました!
統計データ:

過去 24時間: 0

過去 7 日: 2

過去 30 日: 2

今までの合計 47