評価: 263
5
13
Hi I got an IP5s regarding charging issue. The things that I already changed :
Checked lines :
Not yet change Q2, because the C304 showing normal volt to me
What should I do next ? Do i need to change the Q2 as well ?
この質問は役に立ちましたか？
評価: 221.4千
15
289
806
Q2 is fine. This MOSFET is configured as a reverse voltage protection circuit so if you are seeing voltage on either side, then it is working fine. The problem here is that the voltage you are measuring is low. You should be reading ~5V as this is coming from the charger. What exactly kind of charger is it connected to? You should put an ammeter inline to see what the current draw is.
このアンサーは役に立ちましたか？
The ammeter didnt show any current going through the circuit. Do i need to try with a different charging port ? Or it is make sense if the U2 is not soldered properly ?
If you have no current draw, that means the phone isn't really trying to boot. This could be caused by a short or an improperly soldered Tristar.
Hi. I already changed a new U2 but still not charging. What do u think the problem is ?
過去 24時間: 0
過去 7 日: 0
過去 30 日: 0
今までの合計 174
