修理を始めるには コミュニティ ストア

2014年9月19日に発売されたiPhone 6の修理情報とガイドです。モデル番号 A1549、A1586、A1589。

4994回答 すべてを表示

オプション

Phone crashed while testing new screen (no screws installed) iTunes ok

I was replacing a screen assembly on iphone 6. before putting the screws back in I turned the device on and tested it. it was working fine. The digitizer shifted a tiny bit (maybe it pulled a connector off?) but the phone went off entirely. I have not been able to get it back on since. I did try a second brand new replacement screen assembly (known good) and it does the same thing.

I can power on the phone and iTunes DOES see and communicate with it.

I installed the screen again (no home button or any connectors except the screen and digitizer) - powered on, used a flashlight and could NOT see anything on the screen in the dark.

All pins on connectors look good. I dont thinks the backlight filter since I cant see anything with a flashlight.

Any ideas or suggestions. Thanks

この質問に回答する 同じ問題があります

この質問は役に立ちましたか？

はい いいえ
スコア 0
1件のコメント

I should mention, I did not put any screws in so it did not short anything out that way.

さんによる

コメントを追加

1 件の回答

フィルタ：
参考になった順 新しい順 古い順
最も参考になった回答

オプション

First thing would be to take a close look at the connectors and surrounding areas for any physical damage. If you cannot see anything at all even with a clean screen and a flashlight, you may be looking at a display IC. If just the backlight goes out you can still see a faint image, but if just the display driver (u1501) or display boost (u5302_RF) goes out you can usually still see a backlight on with the screen outside of the frame. Hope this helps, but always start with the easy stuff, like looking over the board for physical marks.

このアンサーは役に立ちましたか？

はい いいえ
スコア 1
コメントを追加

回答を追加する

Kyle B さん、ありがとうございました！
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 42