メインコンテンツにスキップ

モデル番号A1311 / Mid 2010 / 3.06 & 3.2 GHz Core i3もしくは3.6 GHz Core i5プロセッサ

342回答 すべてを表示

Turns on show apple logo and loading bar then cuts off

hi, I am mainly a phone repair store but usually will take a look at any electronics people bring in. today i was brought a iMac emc 2389 and when i turn it on it shows the apple logo with a loading bar, the fans seem to spin at max rpm and the bar makes it to halfway before the machine turns itself off and then restarts. i tested the psu and it gets 12v on pin 4 and 4.6v on pin 6, so im thinking the psu is still working. the 4 troubleshooting leds all illuminate. so im just looking for some advice on what i can check next. like i said im focused on phone repair so i dont have alot of experience working with macs, i know how to solder and read schematics just not sure where i should even start on this one.

この質問に回答する 同じ問題があります

この質問は役に立ちましたか?

スコア 0
コメントを追加

1 件の回答

最も参考になった回答

Well, you should start by making a PRAM reset and a SMC reset.

PRAM reset:

- With the iMac turn off: Press Cmnd, Option, P and R Keys while starting the Mac, release the power button but continue pressing the other keys. (you have to make sure you get those keys pressed before the gray screen comes up or it won’t work.)

- It will start and chime, then it will reset, keep pressing for 2 chimes and release all.

If the Problem continues do the SMC reset:

- Shut down your Mac

- Disconnect the power cord

- Press and hold the Mac’s power button for 5 seconds

- Release the button

- Reattach the power cables and boot the Mac as usual

If the problem persist you might need to run the apple diagnostic online:

- Power on the iMac and immediately press and hold D.

- Follow the on-screen instructiosn

このアンサーは役に立ちましたか?

スコア 1

1件のコメント:

Really helpful. Did a PRAM reset thanks to the idiotproof instructions and my Mac restarted after many unsuccessful attempts. Thank you!

さんによる

コメントを追加

回答を追加する

lukerockhill さん、ありがとうございました!
統計データ:

過去 24時間: 0

過去 7 日: 2

過去 30 日: 9

今までの合計 7,510