メインコンテンツにスキップ

修理を始めるには

修理する権利

パーツ&ツール

A general-purpose audio device that transmits low audio frequencies to your ears.

15の回答 すべてを表示

My subs not giving bass as I expected

Previously I had one 10 Jl audio bassWedge and another one was Eclipse 12 both subs were around 500rms and my amp is kenwood 1000w peak and 500rms this combination was awesome amazing bass all over, however, recently I bought twin 12'' kicker comps series sub and the issue I'm having is I'm not getting much bass as I used to and when I turn the volume up my car lights dims which not used to happen before so what is wrong and how I can fix it?

この質問に回答する 同じ問題があります

この質問は役に立ちましたか?

スコア 0
コメントを追加

Nintendo Switch Kits

A quick fix to get back in the game

Shop Switch Kits

Nintendo Switch Kits

A quick fix to get back in the game

Shop Switch Kits

1 件の回答

最も参考になった回答

Sounds like your battery is bad, alternator not charging, upgrade battery to higher capacity or run additional auxiliary battery. Are you running the speakers at 2ohms this wiring configuration will demand more power to drive the amps. Confirm your amp power cable size 4awg or larger is good add AUDIO CAPACITORS 1farad or higher rating to your amps should prevent headlights from flickering. Have your battery tested under load, confirm your alternator is charging your battery properly. Check all ground wires to your amps. Bad ground will reduce power to your amps. If all else fails have a reliable audio shop look at your setup.

この回答は役に立ちましたか?

スコア 2

コメント:

My amp wiring is 8awg and I'll try to upgrade it to 4awg. Anyway, yesterday I just realised that fuse is melting from amp side(like there are 2 sides one side goes to battery other towards amp the side towards amp) is that happening because of new subs and load or what?

Hope to hear soon Thank you

さんによる

Looks like the wire is to small gage to handle the amps power demands. Check connections or lose cables clamps. Clean battery terminals thouroughly high resistance will cause the wire to heat up, danger wires overheating may cause a vehicle fire. On your main amp wiring from the battery you should have the proper size Inline fuse connection approx 2ft from the battery in the engine compartment this is a required safety measure to protect your vehicle not your amps. Keep the inline fuse away from high temp heat sources such as the exhaust manifold.

さんによる

コメントを追加

回答を追加する

jassasingh_matharu さん、ありがとうございました!
統計データを表示:

過去 24時間: 0

過去 7 日: 2

過去 30 日: 29

今までの合計 443