メインコンテンツにスキップ

2014年9月19日に発売されたiPhone 6の修理情報とガイドです。モデル番号 A1549、A1586、A1589。

4994回答 すべてを表示

This question is about IP6 Backlight Driver Pads (C2/B2)

This is an iPhone 6 with no prior repair attempt that was last working a few days ago and sent in to me for touch issue repair. After the Meson Chip (U2402) replacement the screen not showing any image. On DC power supply, high current is consumed after prompt to boot, so I think the phone is turning on but not showing any display/image. My diagnostic thinking is the backlight driver were heat up when I was replacing the Meson Chip (U2402). So I take a further step to replaced the Backlight Chip (U1502), when I removing the chip from the board and suddenly the two pads are GONE ! The pads known as C2 and B2. I wonder what are these two pads responsible for ? Does this two pads is important for the phone to boot up normally ? ZXW Tools showing that these two pads are going under the Processor (U0201) and PMIC (U1202).

So what should I do next ?

回答がありました! 回答を表示 同じ問題があります

この質問は役に立ちましたか?

スコア 0
コメントを追加

1 件の回答

ベストアンサー

Yes, those two pads are critical as they are part of the communications protocol for that IC and speaking directly to the CPU & PMIC. You are fortunate in that those lines are available via PP1300 & PP1301 which are located next to the PMIC.

Block Image

However, you will need to remove either Cumulus or PMIC to get full access to them and you will need to use very small jumper wires, such as 0.02mm.

このアンサーは役に立ちましたか?

スコア 2

1件のコメント:

Thnx sir very helpful (Y)

さんによる

コメントを追加

回答を追加する

Azim WHITE さん、ありがとうございました!
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 137